Multiple machines controlled wirelessly for lifting and lowering, some machines cannot keep up with operations

When using wireless remote control to operate multiple machines for lifting and lowering, it's possible that 1-2 machines may not keep up with the commands issued by the remote control, or other machines may operate independently following the remote's commands. Some machines may not operate at all due to frequency issues where the command signal is not received properly.

Solution:

• Raise all machines to the top and then lower them again.

• Hold down the remote control button a little longer, press for 3 seconds before releasing. The machines need time to receive the command.

• Power off the machines, then reconnect the power supply to reset.

(If the problem persists, contact customer service online for further assistance.)